Help getting started
Posted: 28 Oct 2014, 12:10
Hello, I have a 2004 base sentra, and can't get anything to come up on the ECM tab.
I have a USB OBD-II-2 KKL 409.1 OBD2 Cable VAG-COM for VW/AUDI. I have set the cable to Generic and ran a scan on the ECU and found one on 10 and one on 58 while the engine is off.
When I attempt to connect to the ECM it says connected and flashes the keep alive (I think) message in the lower right.
However, the only buttons that are active are the log analyzer and data replay. I have not purchased the software yet as I wanted to ensure compatibility before buying.
Am I doing something wrong? Or do the ECM buttons activate only when the software is activated?
I have a USB OBD-II-2 KKL 409.1 OBD2 Cable VAG-COM for VW/AUDI. I have set the cable to Generic and ran a scan on the ECU and found one on 10 and one on 58 while the engine is off.
When I attempt to connect to the ECM it says connected and flashes the keep alive (I think) message in the lower right.
However, the only buttons that are active are the log analyzer and data replay. I have not purchased the software yet as I wanted to ensure compatibility before buying.
Am I doing something wrong? Or do the ECM buttons activate only when the software is activated?