Page 1 of 1
NEW NDSI function
Posted: 07 Mar 2013, 11:49
by onephatser
Any possibility you might be able to implement a program so that I can see what my oxygen sensor that's in the catalytic converter is reading as far as voltage?
Re: NEW NDSI function
Posted: 07 Mar 2013, 16:27
by Tom
What gauge options do you get when you go to Settings->Data Display ECM?
Re: NEW NDSI function
Posted: 07 Mar 2013, 23:52
by onephatser
It gives me O2 sensor bank 1 sensor 1 and WBO2 sensor. I need O2 sensor bank 1 sensor 2. This function is not supported with NDS1.
Re: NEW NDSI function
Posted: 11 Mar 2013, 22:54
by onephatser
The catalytic converter sensor is not supported with NDS1. Is there a possibility that this could be implemented? The whole reason I bought the software was to be able to read that sensor.
Re: NEW NDSI function
Posted: 17 Mar 2013, 00:48
by seb.racing
yes, the O2 sensor is supported by NDS1
you must go to Data Display Setup
selected O2 sensor
Re: NEW NDSI function
Posted: 17 Mar 2013, 20:48
by onephatser
It does not work for the sensor in the catalytic converter.
Re: NEW NDSI function
Posted: 18 Mar 2013, 04:20
by seb.racing
This is what car?
Re: NEW NDSI function
Posted: 18 Mar 2013, 23:36
by onephatser
1998 Nissan 200sx with the SR20DE engine.
Re: NEW NDSI function
Posted: 19 Mar 2013, 09:23
by seb.racing
you have an O2 sensor before and after the catalyst
try the Live Register Test
normally the NDS1 has fontion for both O2 sensor
http://home.exetel.com.au/nds/NDSI/pict ... ogging.jpg
Re: NEW NDSI function
Posted: 27 Mar 2013, 00:22
by onephatser
It does in fact support the rear oxygen sensor. The parameter for it is oxygen sensor B1.
