Page 1 of 2
pressure sensor intake 200sx S14 SR20DET
Posted: 17 Jan 2012, 20:11
by seb.racing
hello
I have a question on my SR20DET
I have a pressure sensor on the intake air duct
but the NDS gives no function used for the sensor information
is there a manipulation for the NDS uses this information?
thank
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 18 Jan 2012, 10:09
by Tom
No, sorry. The NDSI software can not monitor the boost sensor. It might be possible to add it in the next software release.
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 18 Jan 2012, 19:46
by seb.racing
ok, yes it would be great if you can add the function
+ Function airbag and abs
you have a lot of work for the next release
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 19 Jan 2012, 11:09
by Tom
I've got the Air Bag and Diesel support almost implemented. I will release it once is done and tested.
ABS support will take a little bit longer.
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 19 Jan 2012, 20:03
by seb.racing
strongly the new version
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 30 Sep 2014, 06:06
by seb.racing
I have a question about the information the boost sensor
What is the unit of measure?
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 30 Sep 2014, 12:41
by Tom
If I remember correctly it's voltage.
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 01 Oct 2014, 06:23
by seb.racing
voltage in mV?
because, the display is minimum 0 and maximum 250
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 10 Oct 2014, 06:15
by seb.racing
the unit of measure could be the kPa?
250kPa ≈ 2.5bar ≈ 36psi
Re: pressure sensor intake 200sx S14 SR20DET
Posted: 10 Oct 2014, 23:00
by Tom
What readings are you getting? Does it go above 5.1?