Search found 7 matches

by dmarkus314
12 Feb 2024, 10:46
Forum: Nissan DataScan II
Topic: Interpreting Cylinder Power Tesr
Replies: 0
Views: 91

Interpreting Cylinder Power Tesr

All 4 Cylinders on: Min 788, Idle 788, Max 812

no.1 Off: 625, 962, 975

2: 600, 958, 975

3. 625,925,1050

4. 700, 962,962

What am I to make of this? Thank you.
by dmarkus314
12 Feb 2024, 10:10
Forum: Nissan DataScan II
Topic: Peddle & Throttle Valve Relearn
Replies: 2
Views: 1095

Re: Peddle & Throttle Valve Relearn

Thanks Tom! I tried to post earlier but was unsuccessful. I cannot seem to find it on my display anymore, what gives? Are there software updates to be had, thanks a bunch.
by dmarkus314
01 Jul 2023, 11:47
Forum: Nissan DataScan II
Topic: Peddle & Throttle Valve Relearn
Replies: 2
Views: 1095

Peddle & Throttle Valve Relearn

Do these two procedures need to be performed manually before employing the IAVL feature on NDS 2? The FSM lists them as prerequisites in addition to the necessary conditions regarding coolant temp, load, etc.
by dmarkus314
01 Jul 2021, 13:43
Forum: Nissan DataScan II
Topic: Large Vapor Leak
Replies: 4
Views: 3884

Re: Large Vapor Leak

I had the same issue with gas smell in the cabin and it was a bad vent valve solenoid located on LH (drivers side) rear wheel by charcoal canister. Remove wheel for best access.
by dmarkus314
01 Jul 2021, 13:23
Forum: Nissan DataScan II
Topic: Can connect only to ECM and SRS
Replies: 3
Views: 3685

Re: Can connect only to ECM and SRS

As the man Tom says, NDS II is only able to communicate with the ECM and SRS for Sentra B15 QG18DE 1.8L (mine's '05)
by dmarkus314
19 Mar 2021, 12:54
Forum: Nissan DataScan II
Topic: Gauges
Replies: 2
Views: 2662

Re: Gauges

Please disregard (delete) my previous post: I was in "parameter settings" when I should have been in "display settings" -I'm up and running now.
by dmarkus314
19 Mar 2021, 12:26
Forum: Nissan DataScan II
Topic: Gauges
Replies: 2
Views: 2662

Re: Gauges

I also am having problems setting up the gauges initially. I am following the prompts in data display settings to establish parameters (I'm just saving the defaults), but all of the gauges remain unassigned. What am I missing?