The Nissan DataScan II is intended for newer Nissan cars equipped with gray 16 pin OBDII connecter and use Consult II protocol over K line (DDL2). The connector is usually located near the fuse box.

A list of cars that the software has been tested on is located on the Supported Vehicles page. The list is by no means comprehensive and is constantly being updated as new vehicles are tested.

The software can be used with the BlaztII design adaptor and a generic "dumb" VAG COM OBDII adaptor. The ELM adaptors are not compatible.

The Nissan DataScan II software supports factory Nissan ECUs. Aftermarket ECUs like Apexi Power FC or F-Con V Pro are not compatible with the software.

The latest software release supports diagnostics of following control modules: ECM, BCM, TCM, ABS, SRS and ECMD (ECM Diesel) over the K line (DDL2). Note: Some vehicles may use K line for diagnostics of engine ECU (ECM) but still use DDL1 line for diagnostics of other control modules. This software does not support diagnostics over the DDL1 line.

You can purchase the NDSII software and adaptor from Buy Now page.